What areas of squeegee evaporator are widely used?
Apr 21, 2019
Leave a message
The squeegee evaporator relies on these forces to create material acceleration and enters material to ensure that the heater surface is completely wet,independent of the evaporation ratio or feed rate.Local material overheating and thermal degradation are thus reduced or eliminated altogether,during which the light group (low boiling point) downstream (and liquid film) is operated by horizontal thin film evaporation in a vapor-liquid separator,where the droplets and foam are separated by steam-fluid The resulting pulverized liquid phase,the separated vapor body enters the external capacitor or the next step,and the recombination climbs along the hot wall to the small end outlet.
The scraper evaporator is mainly composed of a hot sheath and a scraper.The inner sleeve is set with hot steam.The scraper is mounted on the rotating shaft.The scraper and the hot sheath wall maintain a small hole,usually 0.5 ~ 1.5 mm,in the upper part of the liquid after preheating the evaporator.The tangential direction,in the effect of gravity and rotating razor,distributes the downward spiral film on the inner wall and evaporates continuously during the descent process,the finished liquid is discharged from the bottom,and the two steam escapes from the top.In some cases,the evaporator can evaporate Solution,a solid product is obtained directly at the bottom.

