How to prevent fire when using high pressure reactor?

1) The fuse used in the stainless steel reactor must comply with the allowed power consumption of the laboratory.
2) The safe energization capacity of the wire should be greater than the electrical power of the high-voltage reactor.
3) If there are flammable and explosive gases such as hydrogen and coal gas indoors, avoid sparks. When the relay is working and switching the switch, sparks are easily generated, so be especially careful. When electrical contact points (such as electrical plugs) have poor contact, they should be repaired or replaced in time.
4) If a fire breaks out in a wire, immediately cut off the power supply and use sand or carbon dioxide or carbon tetrachloride fire extinguishers to extinguish the fire. Do not use conductive liquids such as water or foam fire extinguishers to extinguish the fire