Maintenance of thin film evaporator

Nov 18, 2019

Leave a message

1) The reducer lubricating oil is 40 # oil, and its refueling amount should be within the indicated height. Too much oil will cause stirring and heating, and too little oil will cause the oil film of the eccentric shaft pump to break and cause heat to increase the temperature. Change the secondary lubricant within 1 month when starting to use, and change the lubricant once every 3-4 months.

2) After opening the low head, unscrew the bottom bolt of the U-groove of the rotor, and check the scraper every four months to replace the scraper.

3) Open the bottom bearing every two months, check the bottom bearing for wear, and replace the bottom bearing if necessary.

4) According to the nature of the material, the inner cylinder should be soaked and cleaned regularly with warm water or solvent.

5) Add sealing fluid to the mechanical seal cavity once a month, and the sealing fluid is 20 # mechanical oil.

https://www.heczb.com

Send Inquiry