We know that we only thrive if we could guarantee our combined price tag competiveness and quality advantageous at the same time for Thin film evaporator device for sale, Vacuum Evaporation System, MVR evaporator. We always make unremitting efforts to introduce and cultivate talents, and pay attention to the training and learning of employees and the improvement of technical skills. Under the philosophy of the quest for survival through quality, and the search for development through honor, we pursue leading-edge technology and do our best to provide satisfying products and high quality services to new and old customers.

Introduction

Some compounds have very high boiling points.To boil such compounds,it is preferred to reduce the pressure at which the compound boils rather than increase the temperature.Once the pressure is reduced to the vapor pressure of the compound(at a certain temperature),the compound begins to boil and the distillation can proceed.This technique is known as vacuum distillation and is commonly found in laboratories in the form of vacuum vaporizers.This technique is useful for compounds whose boiling point exceeds their decomposition temperature at atmospheric pressure,and attempts to boil such compounds at atmospheric pressure will cause them to decompose.

Use

1.When installing the vacuum distillation instrument,you must select a rubber stopper of the appropriate size,preferably a grinding vacuum distillation unit.

2.Distillate contains a large amount of low-boiling substances,which must be distilled under normal pressure to distill most of the anti-mesh,and then distilled under reduced pressure with a water pump to remove low-boiling substances.

3.Stop heating,recover low-boiling substances,and check the connection of each part of the instrument to make it close.

4.Turn on the oil pump,then slowly close the safety valve and observe if the pressure on the pressure gauge reaches the requirement.If the requirement is not met,the safety valve can be used for adjustment.

5.When the pressure reaches a constant level,start heating the distillation bottle.When rectifying the monomer,a small amount of zeolite should be added to the distillation flask(usually an oil bath is used,and the temperature is higher than the boiling point of the distillate by 20 to 30 °C.The volatile high boilers can be 30 to 50 °C higher in the later stage.6.After the distillation is finished,remove the heat source first,wait a little colder,and then gradually open the safety piston.When the balance of the mercury column in the pressure gauge drops,stop pumping.After the pressure is balanced inside and outside the system,remove the instrument and clean it.

Our advantages

1.Short Delivery time:We do our best to produce products for you,generally takes about 60 days,we can delivery soon.

2.Safe packing:We will pack your products and minimize the possibility of damage.Finally be packed with seaworthy package or in wooden case.

3.Best after-sale service:Over 60% products are sold to the Southeast Asia,Middle East and Europe,and all products are trusted by domestic and foreign customers.

We are committed to provide Multifunction Distillation Unit Short Path Distillation 10L with Chiller and Vacuum Pump that is reliable and simple to use relying on our scientific and process management, as well as continuous innovation and improvement. We implement our ideals into actions, meet all challenges with firm beliefs, and complete our work successfully. We keep the path of green development and promote the company's product transformation and upgrading.

Hot Tags: vacuum distillation unit, China vacuum distillation unit manufacturers, suppliers, factory, rotary evaporator with motor lift, ceramic drying equipment, Laboratory Evaporators, Distillation pilot plant, drying quality, OEM Thin film evaporator device